Yamaha SRCD Manual de usuario descargar pdf (Pagina 23)

CHAPTER2 Ethernet Unit

2-6 Checking the connection with “ping”

Once you are finished with the network settings, make a check with “ping” to confirm

that you can send and receive data normally. Here, “ping” is a network diagnostic tool

incorporated into the OS as a standard feature. A simple description of how to use “ping”

incorporated into Windows 98 is described below so refer to it when needed. If using

“ping” while incorporated into another OS or TCP/IP protocol, then consult the instruc-

tion manual for that particular device.

1) Click the “Start” button, point to “Pro-

grams,” and then select “MS-DOS

Prompt” to open the MS-DOS window.

2) Run the ping command.

You will see a cursor at C:¥WINDOWS>

on the screen. Enter,

ping xxx.xxx.xxx.xxx

and press the Enter key.

In the xxx.xxx.xxx.xxx portion, enter the

controller IP address.

The address for the controller in the fig-

ure on the right (middle) is 192.168.0.2.

This example shows normal communica-

tion status.

3) The right (bottom) figure shows normal

communication has not been established.

If this happens, recheck the network de-

vice and settings, and eliminate the trou-

ble.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 49 50

Sin comentarios

Yamaha SRCD Manual de usuario Pagina 23