Yamaha MZ300 Manual del operador descargar pdf (Pagina 15)

15 — English

OPERATION

Maintenance Warning System

At every 100 hours of use, the GenSmart

™

monitoring sys-

tem will display a flashing message informing the operator

to service the engine as required by the engine operator’s

manual. To reset this message, push and hold the select/

reset button located underneath the GenSmart

™

display for

5 seconds.

NOTE: Be careful to only press and hold the reset button

when you want the maintenance panel to be reset.

MOVING THE GENERATOR

See Figures 12 - 13.

 Turn the engine off ( O ). Disconnect any equipment that

is plugged into the generator.

Turn the fuel valve to the OFF position.

 Allow 30 minutes of “cool down” time before storing the

machine.

For security, insert the handle lock pin to secure the

handle before moving.

NOTE: To help keep the handle lock pin securely in the

hole, push the joined area of the lanyard toward the inside

of the generator frame.

 With your foot on the rear of the frame, tilt the machine

toward you until it balances on the wheels, then roll the

machine to the desired location.

LIFTING THE GENERATOR

See Figure 14.

 Fold the handle to the down position. Never lift or carry

this product using the handle.

NOTE: This tool is heavy and requires several people to lift.

To avoid back injury, keep your knees bent and lift with your

legs, not your back, and get help when needed.

CAUTION:

On a level surface with the engine off, check the

lubricant level before each use of the generator.

STARTING THE ENGINE

See Figure 15.

NOTE: If location of generator is not level, the unit may not

start or may shut down during operation.

Unplug all loads from the generator.

Turn the fuel valve to the ON position.

Move the choke lever right to the START position.

NOTE: If engine is warm or the temperature is above

50˚F, move the choke lever left to the RUN position.

Pull the recoil starting grip until the engine runs (a maxi-

mum of 6 times).

NOTE: Do not allow the grip to snap back after starting;

return it gently to its original place.

Allow the engine to run for 30 seconds, then move the

choke lever left to the RUN position.

STOPPING THE ENGINE

See Figure 16.

To stop the engine under normal operating conditions:

Remove any load from the generator.

To turn the engine off, press and hold the OFF switch until

the engine stops.

Turn the fuel valve to the OFF position.

WARNING:

While operating and storing, keep at least 3 feet

of clearance on all sides of this product, including

overhead. Allow a minimum of 30 minutes of “cool

down” time before storage. Heat created by muffler

and exhaust gases could be hot enough to cause

serious burns and/or ignite combustible objects.

HIGH ALTITUDE OPERATION

Specific modifications are needed for high-altitude operation.

Please contact your authorized service center for important

information regarding these modifications. Operating this

engine without the proper altitude modification may increase

the engine’s emissions and decrease fuel economy and

performance.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Comentarios a estos manuales

Sin comentarios

Yamaha MZ300 Manual del operador Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Yamaha MZ300