Yamaha MZ360 Manual del operador descargar pdf (Pagina 16)

10 — English

PRODUCT SPECIFICATIONS

ENGINE

Engine Type ....................... Yamaha MZ360, 4 Stroke, OHV

Fuel Volume ................................................................ 8 gal.

GENERATOR

Rated Voltage .....................................................120V/240V

Rated Amps ..................................................... 56.7A/28.3A

Rated Output .......................................................... 6,800 W

FEATURES

Maximum Output....................................................8,500 W

Rated Frequency ........................................................60 Hz

DIMENSIONS

Length ....................................................................... 36 in.

Width .......................................................................... 23 in.

Height ......................................................................... 26 in.

Weight .................................................................... 245 lbs.

KNOW YOUR GENERATOR

See Figure 3.

The safe use of this product requires an understanding of the

information on the product and in this operator’s manual as

well as a knowledge of the project you are attempting. Before

use of this product, familiarize yourself with all operating

features and safety rules.

AC CIRCUIT BREAKER

The circuit breaker is provided to protect the generator

against electrical overload. The circuit breaker may be reset

by pressing the circuit breaker reset button.

AIR FILTER

The air filter helps to limit the amount of dirt and dust drawn

into the unit during operation.

CHOKE LEVER

The choke lever is used when starting the engine.

ENGINE SWITCH

The engine switch is used either alone or in combination

with the recoil starter grip to start the generator. To turn the

engine off, place either engine switch in the “OFF” position.

FUEL TANK

The fuel tank has a capacity of 8 gallons.

FUEL VALVE

Fuel flow from the fuel tank to the engine is turned on and

off using the fuel valve.

GenSmart™ MONITORING SYSTEM

The GenSmart monitoring system tracks usage and load

and alerts the operator when periodic engine maintenance

is needed.

NOTE: GenSmart

™

load indicator monitors the load only

for the 120 Volt, 20 Amp GFCI outlets on the removable

control panel. It does not measure load on the 240 Volt,

30 Amp outlet.

GROUND TERMINAL

The ground terminal is used to assist in properly ground-

ing the generator to help protect against electrical shock.

Consult with a local electrician for grounding requirements

in your area.

IDLE CONTROL SWITCH

When running a load of more than 300 watts, turning on the

idle control switch will allow the generator to sense when no

load is present. In response, the generator will begin idling at

a lower RPM, which will help conserve gasoline and lessen

the noise being produced by the generator.

OFF SWITCH

The generator has two off switches: one on the removable

control panel and one on the stationary control panel. To

turn the engine off, press and hold the OFF switch until the

engine stops.

OIL CAP/DIPSTICK

Remove the oil fill cap to check and add lubricant to the

generator when necessary.

OIL DRAIN PLUG

When changing the engine lubricant, the oil drain plug is

removed to allow old engine lubricant to be drained.

RECEPTACLES

The following single phase, 60 Hz outlets on the control panel

can be used for operating appropriate equipment, electrical

lighting, tools, and motor loads: 2 x 120 Volt duplex GFCI 20

Amp receptacles, and one 240 Volt AC, 30 Amp receptacle.

A 240 Volt AC, 20 Amp receptacle plugged into the side of

the removable control panel is available when the panel is

detached.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Comentarios a estos manuales

Sin comentarios

Yamaha MZ360 Manual del operador Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Yamaha MZ360