Yamaha CDR400c Series Manual de usuario descargar pdf (Pagina 57)

Set up devices

iXOS-JUKEMAN 2.2 User Manual Pre.12/97 57

device=pioneer18 device=pioneer18

drive=\\.\p0b0t3 drive=/dev/iXOS_SCSI0/3

robot=\\.\p0b0t3,1 robot=/dev/iXOS_SCSI0/3,1

disks=1-9 disks=1-9

For the “kubik”, the robot uses a serial interface. The device description

file looks like this:

device=kubik device=kubik

drive=\\.\p0b0t1 drive=/dev/iXOS_SCSI0/1

drive=\\.\p0b0t2 drive=/dev/iXOS_SCSI0/2

drive=\\.\p0b0t3 drive=/dev/iXOS_SCSI0/3

drive=\\.\p0b0t4 drive=/dev/iXOS_SCSI0/4

robot=com2: robot=/dev/ttya

For NSM jukeboxes “cdr100”, “mercury”, and “satellite”, a single serial line

controls up to 16 jukeboxes. An additional line robid=<id>, specifies the

ID of the robot on the serial line. Each NSM jukebox has an ID from 0 to

15, which can be checked and set by the Mercury’s or Satellite’s menu, or

directly in the CDR 100 (see NSM manual). A device description file for a

Mercury 20 with Robot ID 7 should look something like:

device=mercury device=mercury

drive=\\.\p1b0t0 drive=/dev/iXOS_SCSI1/0

drive=\\.\p1b0t1 drive=/dev/iXOS_SCSI1/1

robot=com2: robot=/dev/ttya

robid=7 robid=7

Alternatively, the following syntax can be used to define the serial inter-

face and robot ID in one line:

robot=com2:,7 robot=/dev/ttya,7

3.4.5 Further points to note

Make sure the device to be set up is connected properly and operational.

Note: The section “Supported jukeboxes” on page 163 provides you with

more specific details about the supported jukeboxes with sample

device description files, that can be used with minor modifications.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 272 273

Sin comentarios

Yamaha CDR400c Series Manual de usuario Pagina 57