Yamaha R Remote Manual de operaciones descargar pdf (Pagina 5)

R Remote Operation Manual 5

Settings on the R series units

When using R Remote to operate an R series unit, set the DIP switches and [UNIT ID] rotary switch of

the unit, taking note of the following settings.

・ Set the UNIT ID in the range of 1 to 8. R Remote will not detect units with a setting of 0 or 9 or

higher.

・ Set the DIP switches to one of the following states, depending on the connection type and the

START UP MODE.

Connection

START UP MODE

Dip switch

DAISY CHAIN

REFRESH

(↑↑↑↑↑↑↑↑)

RESUME

(↑↑↑↑↑↑↓↑)

REDUNDANT

REFRESH

(↑↑↑↓↑↑↑↑)

RESUME

(↑↑↑↓↑↑↓↑)

If a CL series unit is not connected, we recommend that you set START UP MODE to RESUME. If this is set to

REFRESH, settings must be transmitted from R Remote and Dante Controller each time the R series unit is

restarted. Also, if the REFRESH setting is used and R Remote is connected earlier than the CL series unit, the

orange [SYNC] indicator will be lit.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Sin comentarios

Yamaha R Remote Manual de operaciones Pagina 5